Surface Finishing Craft

Core Strengths

• Complete range of finishes: more than ten processes including polished, honed, leathered, flamed, bush-hammered and sandblasted.
• Specified to the application: surfaces are chosen by climate, use and design intent, so different zones of one project can carry different finishes without losing coherence.
• Executed by experienced hands: finishes are applied by skilled technicians, with the manual element of bush-hammered and antique work depending on control of feel and uniformity.
• Whole package from one line: walls, floors, countertops and edge profiles are completed on the same line, avoiding the colour and gloss mismatch that comes from splitting work between fabricators.

Key Figures

Service Process

1. Requirements: location, traffic, slip requirement and design intent established.
2. Finish proposal: surface and combination scheme recommended by stone type and application.
3. Sample approval: physical samples produced to confirm colour, gloss and touch.
4. Batch production: full package run to sample parameters with finish codes recorded per piece.
5. Finished inspection: uniformity and gloss consistency checked before coding and packing.

Applications

• Zoned polished walls and slip-resistant floors in hotel lobbies
• Slip-resistant treatment for exterior plazas and pool surrounds
• Honed or leathered countertops and feature walls in homes
• Chain stores needing one consistent finish standard

Sustainability & Certification

Finishing relies on mechanical and water-based processes, limiting chemical use; coolant and dust from polishing and blasting enter the plant recycling and extraction systems.

Completing the whole package on one line removes cross-factory transport and duplicate processing, while nesting raises yield and offcut recycling exceeds 85%.

Deep Selection Guide

Choose a finish by asking three questions first: will it get wet, does it need slip resistance, and how easy is it to maintain. Aesthetics should rest on those three answers. Always confirm on physical samples, because the same stone reads very differently by finish — polishing deepens colour while honing and bush-hammering lighten it. Prioritise slip class in exterior and wet areas, and for leathered and antique finishes with strong tactile character, agree the acceptable range of uniformity at sample stage.

• Selection criteria：Put Zoned polished walls and slip-resistant floors in hotel lobbies first in the selection and Complete range of finishes second - that order avoids most downstream disputes.
• Specification & thickness：Surface finishes (8) is the core of the specification and the rest is fine-tuned to Slip-resistant treatment for exterior plazas and pool surrounds; junctions, cut-outs and shaped edges must be spelled out on the fabrication drawing.
• Acceptance & records：Checks on Specified to the application: surfaces are chosen by climate, use and design intent, so different zones of one project can carry different finishes without losing coherence. are completed and evidenced before dispatch and accepted on site by number; production and test records can be pulled by batch when needed.
• Sustainability：Finishing relies on mechanical and water-based processes, limiting chemical use; coolant and dust from polishing and blasting enter the plant recycling and extraction systems. Include this requirement in the acceptance pack and confirm it against local green material standards.

With Surface Finishing Craft, what Hengsheng emphasises is auditability: selection has a basis, fabrication has records, delivery has milestones, and the client holds commitments that can be checked on quality and programme.

FAQ

How do I choose between polished and honed?

Polished has high reflectance and richer colour, suited to walls and interiors wanting opulence, but performs poorly for slip in wet areas; honed is softer in tone with low reflectance, suited to floors and understated spaces. For wet or exterior areas, prioritise slip class and consider bush-hammered, flamed or sandblasted finishes.

Does the same stone look very different by finish?

Yes. Polishing deepens colour and sharpens veining, while honing and bush-hammering lighten the tone and mute the texture. Always confirm on physical samples and seal the approved sample as the basis for production and acceptance.